Chlorinator System M 30 RC is designed for direct feed of gaseous chlorine under pressure, e. g. for open swimming pools and tanks at locations where it is not possible to provide an auxiliary power supply. The capacities of the device vary from 0 – 2000 g/h, functioning on the principle of pressure in the chlorine cylinder with manual feed rate adjustment.
GENERAL
Chlorinator System M 30 RC is designed for direct feed of gaseous chlorine under pressure, e. g. for open swimming pools and tanks at locations where it is not possible to provide an auxiliary power supply. The capacities of the device vary from 0 – 2000 g/h, functioning on the principle of pressure in the chlorine cylinder with manual feed rate adjustment.
The M 30 RC System consists of:
– Pressure regulator
– Diffuser
– Three way valve
– Accessories
OPERATION PRINCIPLE
Chlorine gas under cylinder pressure enters the regulator through the inlet valve, where the pressure is reduced to 1,2 bar. The gas then flows through the rate tube and the rate valve where the desired amount is set. The set amount of chlorine gas goes through the chlorine pipe and three-way valve to the diffuser, where it is mixed with water. The diffuser is equipped with check valve to prevent the water entering the system.
INSTALLATION
System of pressure regulators M 30 RC is equipped with a pressure-reducing valve, which prevents the chlorine gas to enter under high pressure. The pressure is reduced to a 1,2 bar maximum. Exhaust should be made so that the remaining chlorine gas in the pipeline is neutralised. The diffuser should be mounted at least 1,2 m below water level and maximum of 7m – the higher the feed rate the greater should be the depth. Because of the influences of temperature and quality of the media, bubbles and other factors, always choose the deepest point to insure best possible absorption.
Connection to the cylinder: 1” (complies with DIN 477)
Other connections on request!
We will only use your data to send you content that we consider to be of interest to you: presentations of our products and services, information about training courses and participation in trade fairs.
